Tips Cleaning the Dispenser

Tips Cleaning the Dispenser 

If we think that the dispenser does not need to be cleaned because it's just water, it turns out, this assumption is not correct. Especially in our country where the air is humid, sometimes dispenser can also be places breed bacteria. To clean it is not difficult, only with tap water, bleach, small brush and wipe clean only. First unplug the power first
dispenser, having taken a bottle, empty the reservoir by using the cold water. Fill the reservoir with tap water until full, mix one teaspoon of bleach with one cup of tap water and pour into the reservoir. Then brush the inside of the reservoir with a small brush and let stand for 5 minutes. Empty the contents of the reservoir and then wipe again until dry. Residual bleach rinse again with tap water to fill the reservoir with up to 2 to 3 times. Do this 3 or 4 months so that the dispenser free of bacteria.

How do I clean the dispenser?

Electric cold dispenser tube:

• Go to the top of the dispenser
• Drain tube with a pressure valve at the front
• Clean with damp cloth to clean
• Sanitizer wipe again with a tissue or other tissues with an alcohol content of 75%
• Then dry with a clean dry cloth
• Do not forget to clean the outside of the dispenser with a clean damp cloth.

Dispenser electric heat tube: 

•  Do not forget to clean the outside of the dispenser with a clean damp cloth.
• Drain the tube by opening the faucet at the back (for dispensers is high) or below rubber (for mini dispenser)
• Put water on to heat the tube through the cold tube (tube top)
• Press the red tap and do repeatedly (3-4 times). Make sure the heat tube is clean.
• Non-electric cooler (jar)
• Drain jars by pressing the faucet at the front until the water runs out
• Clean with damp cloth to clean
• Sanitize wipe again with a tissue or other tissue with 75% alcohol content
• Then dry with a clean dry cloth
• Do not forget to clean the outside of the dispenser with a clean damp cloth.

Read more > Tips Cleaning the Dispenser

Damage Of The Water Dispenser

Damage to the dispenser is as follows:

1. water coming out through the valve is not cool blue color

• Check the thermostat is located on the back of the dispenser, is positioned on the low?
• if yes, turn the thermostat to the right / high.
• Check the thermostat terminals on two legs, is there a resistance / ohm for electrical current can flow to the compressor?
• Check compressor, whether to operate or not?

if it does not operate check the compressor relay, overload the compressor and wires leading to the compressor.

• Freon leak check on all system piping connections.

2. water out of the bottom of the dispenser

• Check the rubber seal that is on the faucet.
• Check out the THREAD faucets and faucet in the connection, if a leak?
• Check, if the hot water tubes located at the center of a leak?
• Check the hose for draining water that is at the bottom of the tube of hot water, if ruptured or leaking?

3. Water coming out of the faucet is not red hot at all

• Check, whether the heater heaters were damaged, with the tester to measure both the position of the cable terminal on the ohm scale.
• Check, overload on the hot water cylinder, if there is resistance / ohm electrical current to flow.
• Also check the wires leading to the heater heater is broken or frayed? and check the switch on-off heater on the back of the dispenser, if the position on?

Read more > Damage Of The Water Dispenser